Projection data ► Transfer Projection data ► Establish communication
The tab Establish Communication provides settings for the connection set-up to the target device.
The parameters for setting up the connection are automatically adjusted on the basis of the project data.
You only need to adjust the settings on this page in particular cases.
First, the systems tries to contact the target device using the connection set-up parameters.
If this is not possible, the systems tries again to establish the connection by using the default parameters.
If no connection can be established, possible causes are suggested in a message box.
If the connection successfully established, the system switches to the transfer parameters and the connected device is tested.
If the device does not match the project, a corresponding message will pop up.
Nevertheless, the data can be transferred.