Message register

Station parameter ► Falcon series ► Message register

As of the indicated start address of the Message register, the addresses are specified used by the operator interface and the PLC for partially transferring the system data. The indicated address starts with the offset +00 and is called start address.

Dlg_FlcnStationParametersMsgReg

Please note that the length and structure of the message register may vary depending on the driver type. For its exact length and definition please refer to the general specifications of the different drivers.

Within the following table please find the addresses of the system data.

Message register:

Offset	Example S5
+ 00	DB 31.DW 30	Report register (Image switching via PLC)
+ 01	DB 31.DW 31	Histogram register
+ 02	DB 31.DW 32	Password protection	High byte	Low byte
		-> Password level (0-9)		X
		-> Logout time (FF-00 hex)	X
+ 03	DB 31.DW 33	actual image number
		Time register	High byte	Low byte
+ 04	DB 31.DW 34		Day	Month
+ 05	DB 31.DW 35		Year	Hour
+ 06	DB 31.DW 36		Minute	Second

Image switching via PLC:

ChangePageViaSPS_1

It is not possible to call a start or fault message page via the message register (see step 5). See dynamic control word in the LED bit area.