Changing the angle of the device hanging from the yoke.

Vorheriges Oben Nächstes Helps selection copy topic address english version

HMIs, human machine interfacesThin Client, ET / MT 5x8...OperationChanging the angle of the device hanging from the yoke.

 

To adjust the angle of the device hanging from the yoke, proceed as follows:

 

Unscrew the two Allen screws (10) at both sides of the yoke.

 

Fgr_ScrewFixing

 

 

Pull the unlocking studs of the fixing bolts (9) from their latching position and rotate them by 90 °.

 

Fixing bolt (9)

Symb_Caution1_30x30

Caution !

There is a crushing hazard

when mounting the device or adjusting its position.

Bolt

Unlocking stud

Fgr_WarningCrushingHazard

Fgr_FixingKnob2

 

 

Hold the HMI at its centre only.

 

 

Turn the device to the desired position.

Make sure there is a thread (11) behind the hole (10).

 

Fgr_ScrewFixing

Fgr_DeviceHolder

 

Return the unlocking studs of the fixing bolts to their latching position.

Rotate the HMI until the bolt catches in one of the holes (12) of the device bracket.

Screw the Allen screw through the hole (10) in the yoke into the thread (11) of the device bracket.

Tighten the screw.

 

See also:

To Yoke BtnSymbol

 

<< back