Touch Calibration

Vorheriges Oben Nächstes Helps selection copy topic address english version

HMIs, human machine interfacesPanel PC, ET / MT 4x8...System reloadStart Recovery PETouch Calibration


Calibration points, calibration step 1:



The crosses appear on the screen one after the other.


Use the enclosed touch pen to touch the centre of the crosses as they appear.

The cross is replaced by a check mark Symb_CalbrPointSuccFl_66 indicating that the calibration step was successful.

Repeat the process for the next 3 crosses.


The following message appears:




Confirm the calibration by means of the "Confirm" button.


The message window now shows all initialization steps as completed.





The second calibration screen will pop up.


Calibration points, calibration step 2:



Touch the tip of each arrow.


Once the last calibration point has been set, the device will be rebooted.




<< back next >>