Installation

Vorheriges Oben Nächstes Helps selection copy topic address english version

AccessoriesReadersSK-200Installation

 

The only mechanical connection is the Binder plug, which should be connected to the Binder socket of the "VB-BC-3" cable which is (usually) fitted inside the field enclosure.

 

Click to expand or collaps information.   Connecting to ET/MT-xx6-...(Tx or Fx or AT or A)-... (≥ Rev. 2)

 

Click to expand or collaps information.   Connecting to ET/MT-xx7-...

Connecting_Sk200_to_xx7

 

Contacts 1, 4 and 5 of the flanged connector are not occupied.

The RxD wire (contact 2, flanged connector, yellow cable) of the barcode scanner must NOT be connected to the HMI but must be insulated !

 

 

The reader interface parameters (default settings) of the BCSi-SK-200-RSST barcode scanner are:

7 data bits

2 stop bit

No parity

9600 baud

 

 

Please make sure that these reader interface parameters match the settings of the software that receives the scanner data.

 

If this is not the case, you need to change them. **

 

 

**

Please also always refer to the BCSi-SK-200-RSST card reader documentation issued by the reader's manufacturer.

 

 

See also:

Kapitelseite Technische Daten

Kapitelseite Normen und Richtlinien

 

Kapitelseite Kabel, VB-BC-3

 

 

<< back