Assembly notes

Vorheriges Oben Nächstes Helps selection copy topic address english version

AccessoriesReadersPCRi-MifareAssembly notes

 

The PCRi-Mifare card reader is intended for installation in a separate field housing or inside the field housing of the HMI.

 

If the Mifare card reader has NOT been mounted by the manufacturer, a sufficiently large space for mounting must be provided.

The card reader has the following dimensions:

9.8 x 16.5 x 4.05 (without plug) cm (WxHxT)

 

Make a cut-out with the following dimensions:

Width

Length

Depth of cut-out (inc. plug)

Material thickness

84.0 ± 0.5 mm

153.0 ± 0.5 mm

max. 70 mm

up to 10 mm

 

Mount the card reader using all fixing elements included in the delivery.

Fix the brackets in the corresponding gaps of the housing.

 

Optimum sealing:

Tighten the screws lightly.

Check the position of the card reader, ensuring above all that the rubber seals are correctly positioned.

now fully tighten the terminal screws.

 

 

Warnhinweis

IP65 is ONLYachieved with proper mounting on a plane and smooth surface!

 

Warnhinweis

The Mifare card reader housing must be earthed via the earthing screw at the back of the housing !

The wire used must have a minimum cross section of 4mm² !

 

 

See also:

Kapitelseite Installation

Kapitelseite Dimensional drawing

 

 

<< back