Assembly, field enclosure JSi-3

Vorheriges Oben Nächstes Helps selection copy topic address english version

AccessoriesJoystick JSiMechanical installationAssembly, field enclosure JSi-3

 

The JSi joystick is intended for installation in an appropriate desk housing or control panel. It may be installed in any position.

 

If the JSi joystick has NOT been mounted by the manufacturer, a sufficiently large cut-out and a hole pattern for mounting the joystick must be provided.

 

1.Make a cut-out with the following dimensions: (see also cicon2 Mechanical dimensions JSi-3).

2.Mount the joystick inside the cut-out and use the mounting bracket provided to affix the joystick.

3.Tighten the screws lightly.

4.Check the position of the joystick, ensuring above all that the rubber seals are correctly positioned.

5.Now fully tighten the screws.

6.Connect the joystick cable to the corresponding terminal at the operator interface according to the connection diagram.

 

Fgr_MountingClip

Clip the mounting brackets

into the respective notches at the device.

 

Triangular cutout design:

Fgr_ObjectViewJSi_V3

 

<< back