The optional X5 interface provides two serial CAN buses.
The CAN bus (Controller Area Network) is intended for the connection to a Fieldbus system.
The CAN bus must be terminated with 120 Ohm.
It requires the installation of a driver.
The physical interface meets the requirements of ISO 11898-2 (50 kbit/s to 1 Mbit/s).
Level 2 protocol (security / data link):
a.CAN 2.0A (11 bit identifier) base frame format
b.CAN 2.0B (29 bit identifier) extended frame format
The following communication protocols are supported: