Connection overview ET/MT-4x6...

Vorheriges Oben Nächstes Helps selection copy topic address english version

HMIs, human machine interfacesPanel PC ET/MT-4x6...Electrical InstallationConnection overview ET/MT-4x6...

 

The ET-xx6 devices have 4 USB interface channels.

USB0 at X4 for the internal connection of a USBi drive.

USB1 at X5 for the connection of external USB devices.

USB2 at X6 for the connection of an external USBi drive.

USB3 at X7 for the connection of external USB devices.

 

I.S. USB interfaces USB0, USB2

The USB0 and USB2 I.S. USB interfaces (X4 and X6) are intended for the

internal or external connection of USBi drives.

 

The maximum value for the joint power supply of USB0 and USB2 is 500 mA.

 

 

Ex-e USB interfaces USB1, USB3

The USB1 and USB3 Ex-e USB interfaces (X5 and X7) are intended for the connection of external USB devices.

 

The maximum value for the joint power supply of USB1 and USB3 is 500 mA.

 

Hinweis

Please note that the Ethernet connection is either for an optical fiber connection (X10 (-Fx)) or for a copper connection (X11 (-Tx)), depending on the version ordered !

 

The optical fiber connection requires a multimode optical fiber cable with 62.5 µm core diameter and 125 µm external diameter.

 

Cables connected to the Ethernet terminals (X11) must have a minimum cross section of 0.2 mm² (metric) (AWG 24). Which cable cross sections are chosen should be decided on the basis of relevant regulations, such as DIN VDE 0298 . Factors that might require a larger cross section, such as current, increased temperatures, cable bundling, etc. must also be taken into account.

 

 

Current versions

Connection
overview
revision 3
BtnSymbol

 

Older hardware revisions:

Kapitelseite ET/MT-xx6-Fx/Tx-..., rev. 2

Kapitelseite ET/MT-xx6..., rev. 1

 

 

<< back