Configuring device, Ethernet

Vorheriges Oben Nächstes Helps selection copy topic address english version

HMIs, human machine interfacesEagle ET/MT-3x6...Connection ofSPSPlusWIN Engineering PCConfiguring device, Ethernet

 

In order to reach the Eagle from the engineering device, you need to set the "Communication parameters". Switch on the operator interface to navigate to the menu.

 

After a few seconds the "Communication" window will pop up. Press the "Exit" button or the F8 function key.

 

The "Setup" window will pop up. Press "F2 Login" to authenticate yourself to the Eagle. An Eagle in the factory state has no password yet, so in this case click on "F1 OK" without any further input if you do not wish to allocate a password. If a password has already been assigned to the Eagle, key this into the input field. The virtual keyboard will then pop up, which you can use to enter the password. Confirm the password with "F1 OK" to log in.

 

In the "Setup" window, press the "F6 Com" parameter button or the "F6" function key.

 

The window for the communication parameters will open. Set the required communication parameters by tapping on the respective fields and entering the value via the virtual number pad.

 

Hinweis

The addresses are segmented, which means that you can explicitly change individual address segments.

 

Hinweis

In the case of a connection via a network you have to ensure that the addresses must be reachable in the PC's network in order to communicate with the Eagle.

 

Confirm your input by clicking on the "F1 OK" button or alternatively by clicking on the "F1" function key.

 

 

<< back