Zerlegung der Kupplung

Vorheriges Oben Nächstes Helps selection copy topic address english version

HMIs, human machine interfacesThin Client ET/MT-5x6AssemblyCoupling assemblyInstallation step 4



Separation of the coupling

Preparation of the coupling

Mounting the coupling

Installation step 1

Installation step 2

Installation step 3

Installation step 4


Lubricate the O-ring seal and place it into the outer groove of the coupling. Then screw the four M6x12 hexagon sockets into the corresponding holes so that they hold but are not screwed too tight.




The coupling is now fully assembled. You can now mount the operator interface plus enclosure onto the stand.




<< back