Stand, Wall- and Ceiling mount

 Vorheriges Oben Nächstes Helps selection copy topic address english version

HMIs, human machine interfaces ► Panel PC ET/MT-4x6... ► Assembly ► Stand, Wall- and Ceiling mount

 

As options, the field devices can be ordered with a stand, a wall or a ceiling mount.

The field devices are mounted onto these with a coupling affixed to the mounting tube.

 

The coupling can be turned for 356° degrees, enabling you to ideally position the device.

 

Mounting versions

Stand

Ceiling

Wall

Pct_StandUp

Pct_TopMount

Upright position

Pct_WallTop

Pct_WallDownward

Hanging mount

 

 

Symb_Caution1_30x30

Note

At this point in the assembly instructions we are assuming that

the mount (stand, wall or ceiling mount) has already been fixed in place.

 

See also:

Coupling
assembly 		BtnSymbol

 

ZoomSymbol

Expl_FloorWallMounting

A.Hanging mounting (ceiling mount)

B.Upright mounting (stand or wall mount)

C.4x M6 Allen screws for mounting to coupling

D.Details of enclosure cut-outs

E.Mounting coupling

F.Mounting tube

Assembly steps:

 

1.If you have not already done so, assemble the mounting coupling.

2.Screw two of the Allen screws (C) into the mounting coupling down to about 4 mm.

➢Select the two threaded holes (2) in the coupling that align with the cut-out (4) in the enclosure.

➢Make sure that you make optimum use of the coupling's (B) slewing range.

3.Place the field housing onto the coupling in such a way that the screw heads of the Allen screws in the coupling slide through the cut-outs (4).

➢Turn the device clock-wise until the stop.

➢Tighten the coupling's Allen screws.

4.Screw the remaining two Allen screws into the two threaded holes (2) of the mounting coupling.

➢Tighten the coupling's four Allen screws.

 

 

 

<< back