Stand, Wall- and Ceiling mount

Vorheriges Oben Nächstes Helps selection copy topic address english version

HMIs, human machine interfacesEagle ET/MT-3x6...AssemblyStand, Wall- and Ceiling mount

 

As options, the field devices can be ordered with a stand, a wall or a ceiling mount.

The field devices are mounted onto these with a coupling affixed to the mounting tube.

 

The coupling can be turned for 356° degrees, enabling you to ideally position the device.

 

Mounting versions

Stand

Ceiling

Wall

Pct_StandUp

Pct_TopMount

Upright position

Pct_WallTop

Pct_WallDownward


Hanging mount

 

 

Symb_Caution1_30x30

Note

At this point in the assembly instructions we are assuming that

the mount (stand, wall or ceiling mount) has already been fixed in place.

 

ZoomSymbol

Expl_FloorWallMounting

A.Hanging mounting (ceiling mount)

B.Upright mounting (stand or wall mount)

C.4x M6 Allen screws for mounting to coupling

D.Details of enclosure cut-outs

E.Mounting coupling

F.Mounting tube

Assembly steps:

 

1.If you have not already done so, assemble the mounting coupling.

2.Screw two of the Allen screws (C) into the mounting coupling down to about 4 mm.

Select the two threaded holes (2) in the coupling that align with the cut-out (4) in the enclosure.

Make sure that you make optimum use of the coupling's (B) slewing range.

3.Place the field housing onto the coupling in such a way that the screw heads of the Allen screws in the coupling slide through the cut-outs (4).

Turn the device clock-wise until the stop.

Tighten the coupling's Allen screws.

4.Screw the remaining two Allen screws into the two threaded holes (2) of the mounting coupling.

Tighten the coupling's four Allen screws.

 

 

See also:

Coupling
assembly
BtnSymbol

 

 

<< back