Panel Mount

Vorheriges Oben Nächstes Helps selection copy topic address english version

HMIs, human machine interfacesKVM-Systems, ET/MT-6x8...Assembly ET- / MT - 6x8 DevicesPanel Mount

 

The xx8 series devices can be installed in a control panel or cabinet.

 

Fgr_PanelMountViewDetl

 

For this, the optional 'xx8 mounting kit' is available.

 

Hinweis

These instructions are based on the installation  "10560310 RevXX xx8 Mounting Assembly Overview" .

You will find these in the operating instructions of the device.

 

Hinweis

The assembly should be carried out by two persons.

 

The following chapters explain how to mount the kit in a control panel (cabinet).

 

Preparation:

 

Cover the holes of the mounting screws with the seals provided.

Remove the cover foil from the back of the seals.

 

Fgr_Seal_Inlay_1

 

Place the top and bottom seal flush with the rims.

Be careful and do not stretch the seals.

 

Fgr_Seal_Inlay_2

 

Place the left and right seal flush with the rim.

Make sure the noses 1) exactly fit the grooves.

 

Fgr_Seal_Inlay_3

 

Once all seals are fitted, it should look like this:

 

Fgr_Seal_Completed

 

Make a cut-out for the device in the control panel (cabinet).

 

Device

Height

Width

xT-438

364 ±1

360 ±1

xT-498

450 ±1

364 ±1

Dimensions in mm.

 

Assembly BtnSymbol

 

<< back