Panel Mount

The xx8 series devices can be installed in a control panel or cabinet.

Fgr_PanelMountViewDetl

For this, the optional 'xx8 mounting kit' is available.

These instructions are based on the installation "10560310 RevXX xx8 Mounting Assembly Overview" .

You will find these in the operating instructions of the device.

The assembly should be carried out by two persons.

The following chapters explain how to mount the kit in a control panel (cabinet).

•Cover the holes of the mounting screws with the seals provided.

➢Remove the cover foil from the back of the seals.

Fgr_Seal_Inlay_1

•Place the top and bottom seal flush with the rims.

➢Be careful and do not stretch the seals.

Fgr_Seal_Inlay_2

•Place the left and right seal flush with the rim.

➢Make sure the noses 1) exactly fit the grooves.

Fgr_Seal_Inlay_3

Once all seals are fitted, it should look like this:

Fgr_Seal_Completed

•Make a cut-out for the device in the control panel (cabinet).

Dimensions in mm.