Device at yoke

 Vorheriges Oben Nächstes Helps selection copy topic address english version

HMIs, human machine interfaces ► Panel PC, ET / MT 4x8... ► Assembly ET- / MT - 4x8 Devices ► Yoke holder ► Device at yoke

 

Assembly yoke at device:

 

Step 1:

 

*1)

If you have ordered the device together with the optional stand and yoke, the device brackets are already mounted on the device.

 

•Otherwise, mount *1 both device brackets at the centre of both sides using the two Allen screws (3) (10Nm).

 

Fgr_ScrewingPosDevHolder

Fixing

thread

 

 

Fgr_DevHolderForYoke2a

 

•Check on both sides that the fixing ring (5) on the bolt of the device brackets fixes the mounting tongue (4) on the very edge of the bolt.

•You may need to push the tongue into the edge position.

Fgr_FixRingPosition_a

Fgr_MontageLascheSicherungsring

 

 

 

 

Step 2:

 

 

•Carefully slide the HMI with the bolts (6) of the brackets on both sides into the slot (7) of the yoke.

 

Symb_Caution1_30x30

Caution !

There is a crushing hazard

when mounting the device or adjusting its position.

Fgr_WarningCrushingHazard

Hold the HMI at its centre only.

 

 

Front

 

Fgr_AslmblDisplayToYoke

Fgr_AslmblDisplayToYoke_Wrong

Fgr_DeviceHolder2Fgr_YokeNuteDetail

 

 

 

Step 3:

 

•Turn the device to the desired position.

➢Make sure that one of the fixing holes (12) is positioned behind the hole (8) in the mounting tongue (4).

 

Fgr_DevMountToYoke_a

Fgr_DeviceHolder

 

•On both sides, screw the fixing bolt (10Nm) through the hole in the mounting tongue (4) and into the thread (8) of the yoke.

➢If the thread is not catching, adjust the position of the device a little so that the fixing bolt slides into one of the fixing holes (12).

•Tighten the fixing bolt with the assembly key included in the delivery.

 

Fgr_DevMountToYoke

 

 

Step 4:

 

•Check whether the device is positioned at the required angle.

•If it is not positioned as required,

a.pull the unlocking studs of the fixing bolts (9) from their latching position and rotate them by 90 °. !!! Caution! Crushing hazard !!!

 

Fixing bolt (9)

 

Bolt

Unlocking stud

Fgr_FixingKnob2

 

 

 

b.Turn the device to the desired position.

c.Make sure there is a thread (11) behind the hole (10).

 

Fgr_ScrewFixing

Fgr_DeviceHolder

 

d.Return the unlocking studs of the fixing bolts to their latching position.

e.Rotate the HMI until the bolt catches in one of the holes (12) of the device bracket.

 

•Screw the Allen screw through the hole (10) in the yoke into the thread (11) of the device bracket.

•Tighten the screw (10Nm).

 

 

<< back